Rorty Designs produced some drawings of Cortina Replacement uprights but I don’t believe they went into production.
Instead of the custom manufactured spindle, maybe a bolt on item such as that from a Ford Sierra could be utilized.
Rorty Uprights
Megasquirt MS1/Extra Rover V8 – Troubles Starting
As many regular readers know, I'd had my Megasquirt MS1/Extra Rover V8 started within a couple turns of they crank. …
Rover V8 Tuner Studio – CTS / ATS Calibration
To successfully use a Megasquirt you must use Tuner Studio to calibrate all your sensors. For a Rover V8 4.6L …
Rover V8 Twin Throttle Bodies
I've been looking into fitting Rover V8 Twin Throttle Bodies. Rover did it on a limited number SD1 Vitesse's. I …
Rover V8 ExtraEfi Megasquirt – Will it run?
There’s been a lot of work getting my Rover V8 Megasquirt engine from ‘looking’ ready to actually ready to start. …
Megasquirt ECU – Rover V8 4.6Ltr
My Megasquirt ECU V8 project is getting close to the point of turning the key. I decided to tidy the …
Rover V8 Locost 4×4 -Wiring and Plumbing
Putting a Rover V8 and 4wd into a Locost was always going to take a long time. Finishing the wiring …
Multiple Radiator Fans
Fitting two fans, one each side of the radiator in a push pull air flow arrangement has made a dramatic …
Rover V8 Trigger Wheel – Megasquirt
A Megasquirt ECU requires a 36-1 trigger input. Many people fit a trigger wheel to the front pulley, however I …