Sierra Upright and Maxi Bottom Ball Joint Reaming
Reaming the Sierra Upright for the Maxi Ball Joint is full of problems. The forum sites are full of all sorts of rubbish about reaming bottom joints. Some of it is potentially lethal.
princess ball joint
Haynes Roadster Mushroom Adaptors
Ford Sierra Mushroom adaptors are available from many Haynes Roadster and Kit Car sources, but I needed some special ones to fit my 4x4 uprights.
Custom Ford Sierra Front Uprights
I had to enrol the skills of the 'brother in law' to TIG weld the new Ford Sierra based...
Ackermann Angle and Sierra Uprights
If you swapped uprights from one side of the car to the other the Ackermann Angle would be very...
Ford Sierra Front Stub Axle
I’m getting better at the CAD stuff. The latest item to get drawn up is the Sierra Group N front...
Megasquirt MS1/Extra Rover V8 – Troubles Starting
As many regular readers know, I'd had my Megasquirt MS1/Extra Rover V8 started within a couple turns of they crank. …
Rover V8 Tuner Studio – CTS / ATS Calibration
To successfully use a Megasquirt you must use Tuner Studio to calibrate all your sensors. For a Rover V8 4.6L …
Rover V8 Twin Throttle Bodies
I've been looking into fitting Rover V8 Twin Throttle Bodies. Rover did it on a limited number SD1 Vitesse's. I …
Rover V8 ExtraEfi Megasquirt – Will it run?
There’s been a lot of work getting my Rover V8 Megasquirt engine from ‘looking’ ready to actually ready to start. …
Megasquirt ECU – Rover V8 4.6Ltr
My Megasquirt ECU V8 project is getting close to the point of turning the key. I decided to tidy the …
Rover V8 Locost 4×4 -Wiring and Plumbing
Putting a Rover V8 and 4wd into a Locost was always going to take a long time. Finishing the wiring …
Multiple Radiator Fans
Fitting two fans, one each side of the radiator in a push pull air flow arrangement has made a dramatic …
Rover V8 Trigger Wheel – Megasquirt
A Megasquirt ECU requires a 36-1 trigger input. Many people fit a trigger wheel to the front pulley, however I …